- #Installing lightburn software to shapeoko 3 xl pdf#
- #Installing lightburn software to shapeoko 3 xl pro#
The arrows shown in the images below illustrate the proper wiring placement.ġ0 watt PLUS laser head installed on SHapeoko CNC frameĭo you have a Shapeoko 3 XXL? This, bud, is for you! Below is one method of mounting the Endurance laser on the Shapeoko CNC.ĭepending on where you mount your laser box, you’ll likely need to thread the cables along the same path as the spindle cables are run. Mounting the Endurance laser on the Shapeoko is completely your preference and there are lots of ways to do so. Changing the GRBL line $32=0 to $32=1 will allow the laser’s intensity to be controlled when executing Gcode files.Īfter downloading the vector-based software and soldering the two wires you are all setup to engrave and cut with your Endurance laser.
Once downloaded the next step is to enable the laser mode via GRBL settings. There are many software options for using a laser on a CNC, examples include: Laser CAD, LightBurn, Fusion 360 and Adobe Illustrator just to name a few. Step 4ĭownload a vector-based laser software.
Step 3 Solder the PWN and GND wires to the Shapeoko Control Board as shown in the photo below. Furthermore, cutting and rejoining more segments of wire will not interfere with any component of the system.
#Installing lightburn software to shapeoko 3 xl pro#
Pro Tip: If you plan to mount the Laser Box on the exterior of an enclosure you may need to extend the wires to the laser itself. These are the PWM & GND cables you will need to solder to the Shapeoko control board. There should be two cables that are not connected to anything yet, one should be black (GND) and the other should be red (PWM). Locate the PWM & GND cables coming from the Endurance Laser Box.
These are the ports the Endurance Laser Box will connect to and allow the laser’s power to be modified.
#Installing lightburn software to shapeoko 3 xl pdf#
Endurance Laser Shapeoko Quick-Start Guide (FULL PDF GUIDE) Step 1įirst, locate the PWN and GND ports on the Shapeoko control board.
0 kommentar(er)
